Victron Phoenix Smart Inverter 12V/2000VA/230V

Installation is simpler than ever before with terminals now more accessible for the installer, enabling a more professional finish. 

Bluetooth built-in: fully configurable with a tablet or smartphone 

• Low battery voltage alarm
• Low battery voltage cut-off and restart levels
• Dynamic cut-off: load dependent cut-off level
• Output voltage: 210 – 245V
• Frequency: 50 Hz or 60 Hz
• ECO mode on/off and ECO mode sense level
• Alarm relay

Monitoring: In- and output voltage, load and alarms 

VE.Direct communication port 

The VE.Direct port can be connected to a computer (VE.Direct to USB interface cable needed) to configure and monitor the same parameters. 

Proven reliability 

The full bridge plus toroidal transformer topology has proven its reliability over many years. The inverters are short circuit proof and protected against overheating, whether due to overload or high ambient temperature. 

High start-up power 

Needed to start loads such as power converters for LED lamps, halogen lamps or electric tools.

ECO mode 

When in ECO mode, the inverter will switch to standby when the load decreases below a preset value. Once in standby the inverter will switch on for a short period every 2,5 seconds (adjustable). If the load exceeds the preset level, the inverter will remain on. 

Remote on/off 

A remote on/off switch or relay contact can be connected to a two pole connector. Alternatively, the H terminal (left) of the two pole connector can be switched to battery plus, or the L terminal (right) of the two pole connector can be switched to battery minus (or the chassis of a vehicle, for example). 

To transfer the load to another AC source: the automatic transfer switch